View Full Version : head stud torque
bill302
09-19-2007, 10:25 PM
tell me the sequence and ft lbs to torque apr head studs. e7 heads and rol gasket....thanks.
QWKSNKE
09-20-2007, 05:00 AM
torque iron heads to around 90 ft/lbs. (start at 35, then 65, then 90)
Pick up a haynes book for your mustang and the tightening sequence will be in there
coupe
09-20-2007, 07:34 AM
here's something I came up with quickly...
coupe
09-20-2007, 07:37 AM
Keep in mind that is for 7/16" fasteners. Being studs, you can add about 5-ft.lbs to the values. 90 seems a little excessive, but I'm sure it works.
My studs have been on for 4 years and I went by the above chart. I have 1011-2 Felpros and aluminum heads.
bill302
09-20-2007, 09:47 AM
90 ft lbs for upper and lower studs....right. and thanks
QWKSNKE
09-20-2007, 10:51 AM
Keep in mind that is for 7/16" fasteners. Being studs, you can add about 5-ft.lbs to the values. 90 seems a little excessive, but I'm sure it works.
My studs have been on for 4 years and I went by the above chart. I have 1011-2 Felpros and aluminum heads.
Cast iron heads are usually tightened to a larger amount than aluminum
vBulletin® v3.8.2, Copyright ©2000-2024, Jelsoft Enterprises Ltd.