TrickFlow head Q's

[banditmwp]

I read on their website that the trickflow twisted wedge street heads (with 2.02/1.60 valves and .540" springs) will work with stock bottom end but require different length pushrods. Anyone happen to know what length or am I gonna have to measure and wait to order them?

I seem to remember hearing 6.750" from one of my customers but not sure if that's right or not.

Also, any other head suggestions? I am looking to spend around $2k on heads, rockers, and some other miscellani (MAF, injectors, AFPR, MSD). I will be running an E-cam for now and a trick flow track heat intake.

Thanks for the advice

[QWKSNKE]

I think you are correct on 6.750 but I would call them to verify

[BAD INT]

you can run several letter cams with those heads and stock bottom end
b with 1.7's or f with 1.6's worst case run an eek.

[qkjuicedpony]

when you call Trick Flow.they will tell you which ones you need.


I would do a b cam and 1.7's though.

[Wickd GT]

6.70" will be fine, thats the ones I had on my stock block and R302 block. Best combination will be B cam with 1.72 roller rockers, it will give a
.516 lift, and pull real hard.

Edgar

[Italian LX]

I just so happen to have a good set of Trickflow hardened 6.700 pushrods that I'll sell you.

:D




http://myweb.cableone.net/blombardi/tfs-6700.jpg

[banditmwp]

I just so happen to have a good set of Trickflow hardened 6.700 pushrods that I'll sell you.

:D




http://myweb.cableone.net/blombardi/tfs-6700.jpg

how much?