air fuel meter

[waypastcrazy]

hey guys I was not sure where to post this.but here goes. I am wanting to hook up a ohms meter inside the car to fine tune my carb. this is the question. Is there a way to hook this up with a 2 wire o2 sensor or do i have to have a 1 wire. reason I am asking is i already have 2 new 2 wire sensors.every dollar saved is a dollar earned. thx for any replies.Robert

[qkjuicedpony]

Take your Digital meter and hook it into the two wire sensor.

set the meter in the car and turn it on.....and there you go...

[SvoBrown]

That will get you close. Some tune with a egt. Exhaust temp. Too hot is lean and cool is too much fuel. I run about 1200 to 1300 with the turbo starting to get red. I think the na. runs cooler than that.
Narrow band O2. I don't know much on them.

[SlowJoe]

u better get that thing tuned in! I have 2nd gear now and ready to strip that yellow car. Lol

[waypastcrazy]

u better get that thing tuned in! I have 2nd gear now and ready to strip that yellow car. Lol

for pinks and how many lengths u going to cry for lol

[SlowJoe]

bring it! i dont need no lengths how about i set u out 3 and beat u by 3.

[waypastcrazy]

yea the scenario would be you set me out 3 and wonder why I beat you by 6 and the answer would be 3+3=6 ha ha!