Engine update, pictures

[Wickd GT]

Well, after Christmas shopping I decided to start settting up the rings, file fit this takes a long time to set the gap, so I did 3 pistons so far, tomorrow I'll probably have the motor complete. The tranny has bee refresh too.

[QWKSNKE]

Do you have to file fit all rings or just the ones you use in your car?

[Wickd GT]

Do you have to file fit all rings or just the ones you use in your car?
I always buy rung that are going to be file fit, example 4.040 bore, so I get 4.045 rings. I gap them pretty wide, .032" top ring and 0.034 second ring, this will prevent the ring from butt each other when the nitrous is hit. I will give me a bit more of blow by, but it keeps the rings in ggod shape. I'm using Hell Fire rings.


Edgar

[NightHawk756]

Looking good Edgar!! ;)

[Ponygirl]

That is a very very clean motor. :chug:

[Wickd GT]

I have it almost done, by tomorrow I'll have it finish and probably in the car.

[QWKSNKE]

Edgar,

if you have time, could you take a couple of pics of the heads, pushrods, and rocker arms installed on the motor. I would like to see what the trickflow heads look like since the valve/ rocker arm placement is rotated a little compared to most heads.

[EZ SPEED]

Its looking great Edgar :chug:

[Wickd GT]

Lee here are the pictures, I finish the engine, and it is in the car and tranny too, so some time this week I'll fire her up.

Edgar

[QWKSNKE]

Thanks Edgar