need some MAF advice

[ncontt]

looking at either the PMAS protube or the SCT BA2400/BA2600/BA2800

any suggestions? Good/Bad/Otherwise?

This is for the fairmont....

Specifics are:
331
Ponydown stage 3 kit
MasterPower T70 (got a deal on this one, wanted bigger but this will do for now)
60# injectors flow matched
Ported cobra Upper/lower (probably a restriction)
built AOD....
blah, blah, blah

[QWKSNKE]

From a tuning standpoint? I don't think you will go wrong with any that you have listed. Are yo planning a draw-thru or blow thru setup?

[93cobra1928]

Lot's of people running both with good results, I have also
been hearing good things about Abaco FWIW

Question: Why did you go 331 instead of 347? Just curious.

[ncontt]

Lot's of people running both with good results, I have also
been hearing good things about Abaco FWIW

Question: Why did you go 331 instead of 347? Just curious.

That's a good question...lol. Long story short, I bought a longblock with everything done to it I had wanted way back when I had the Incon TT setup. Well it ended up being a pile of $h!T, literally, the cam bearings spun out of it, dogbones broke, lifter spun, cam broke in two when I tried to set it to TDC....at any rate, the only thing I could use (what I thought) at the time was the heads (been totally redone since then) and the crank...but crank ended up being jacked up too.

I'm going BLOWTHRU....

[Dale McPeters]

PMAS protube for blow thru applications or the HPX sensor in a 3.5"-4" tube.
I have the excel spread sheet for the HPX sensor transfer curves based on tube size...(Somewhere I think)

On the HPX sensor the bigger the tube that it is in the more range and hp capability you have with the sensor..

[QWKSNKE]

I agree with Dale. Do the PMAS for a blow thru setup

[ncontt]

I agree with Dale. Do the PMAS for a blow thru setup

This is the one I was leaning towards, but a little affirmation is always nice.:chug: