SvoBrown
07-25-2010, 12:39 PM
I'm done! Took a roush side muffler then cut and shaped it to fit the drivers side. I cut a lot out because of the cobra IRS. That takes up all the room.
The special part is you can't see it. The subframe connectors make it almost impossible to run lower springs. unless you go thru the frame. I cut a 3.5" hole where the brake cable runs and ran a 2.5" pipe with a turn down. Did the fiberglass wrap around it and then used very stiff holders to keep it from rubbing.
THe frame is still very strong because of the subframes. IT is quiet again. Loud with WOT but nice to ride around in.
Except for the 100 degree heat. No ac.
The special part is you can't see it. The subframe connectors make it almost impossible to run lower springs. unless you go thru the frame. I cut a 3.5" hole where the brake cable runs and ran a 2.5" pipe with a turn down. Did the fiberglass wrap around it and then used very stiff holders to keep it from rubbing.
THe frame is still very strong because of the subframes. IT is quiet again. Loud with WOT but nice to ride around in.
Except for the 100 degree heat. No ac.