SvoBrown
05-15-2011, 01:13 PM
With the help of a good friend I replaced the channel that the window slides into and the dew wipe inside the door. This was a hard job! the old rubber had turn hard as a rock. took forever for it to come out. Also replace the guides in the window that it runs on so it goes up and down. It is very quiet going down the road now!!!! Windows go up and down with no problem. Took about 6 hours in all.
The inside felt on the door panel had staples holding it in, We went back with pan head screws and cut the threads off that came out the other side. Holds very well! With a little cleaning of the inside panel it looks brand new!
Also for the door panels that have the water damage at the bottom. I used alcohol to get the backer board wet and then with some heavy weight i pressed it flat over night. It was flat once again!!!! Looks brand new,
The inside felt on the door panel had staples holding it in, We went back with pan head screws and cut the threads off that came out the other side. Holds very well! With a little cleaning of the inside panel it looks brand new!
Also for the door panels that have the water damage at the bottom. I used alcohol to get the backer board wet and then with some heavy weight i pressed it flat over night. It was flat once again!!!! Looks brand new,