Eastwood tube flaring tool

[rtusnake]

If anyone plans on doing any brake flaring or hard fuel lines, this tool is awesome. Since i'm redoing all my brake lines, I needed something to make consistent and reliable double flares. I tried using the $30 tool you normally see but had very little luck making a nice flare. This tool will do 45 degree single and double flares in 3/16, 1/4, 5/16, and 3/8 hardline. Very simple to use and all the fittings are on a rotating head.

http://i62.photobucket.com/albums/h85/rtusnake/003-22.jpg
http://i62.photobucket.com/albums/h85/rtusnake/002-23.jpg

[SlowJoe]

:metal:

[EHardy1971]

:nice: I like how they have those fittings on that rotating head, you don't have to worry about dropping and losing them.

[yellowSVT]

so how much does one of those cost? hey u bout ready to help me with the supercharger swap?

[rtusnake]

Tool was $189. You about have all your stuff to do the swap?

[EZ SPEED]

Yeah i like that tool...wish i had it a few months ago when i relocated my ABS module

[rtusnake]

I wish somebody else had one so I didnt have to buy this one :jester:

[yellowSVT]

getting real close still need the rails, daul fpdm, not sure if im gonna use stock hat or fore. it just takes money and im out of it right now!

[lukem80]

man I use the sweet one from VatoZone!

forget that pimp crap

[rtusnake]

Psssh, can't be working to hard

[waypastcrazy]

Dang Michael now I have to get me one.
Thats a nice tool to have.

[rtusnake]

It's nice to have, also had a nice molded case to store it in