PDA

View Full Version : Rear End Components etc.


Dale McPeters
09-26-2005, 12:46 PM
Has anyone on the list ever used any items that these guy's sell?

http://www.mittlerbros.com/rearend_parts_acc.htm

I am going to update to 9" ends for the 8.8 in my car and just happen to run across them on the internet.

Any info appreciated.

Dale McPeters
09-26-2005, 03:47 PM
No replies....:(

Ok can someone make a recommendation for another company etc.?

Uh never mind I just found them on Currie's website and they are cheaper.....duh... :jester:

96GTS
09-27-2005, 12:23 AM
All my parts are from Moser (http://www.moserengineering.com/). Just call them and tell them you want 9" ends that work with stock brakes on an 8.8"

Ends were welded by Currie (http://www.currieenterprises.com/cestore/default_rearend.aspx) (they're local to me).
Gears/pinion setup by a buddy whos an SVT tech at a dealer.
Install done by your's truly;)


http://www.mustangmods.com/data/1619/spool_04.jpg

http://www.mustangmods.com/data/1619/000_0193.jpg

http://www.mustangmods.com/data/1619/000_0192.jpg

http://www.mustangmods.com/data/1619/000_0194.jpg

http://www.mustangmods.com/data/1619/000_0195.jpg

http://www.mustangmods.com/data/1619/000_0197.jpg

http://www.mustangmods.com/data/1619/000_0198.jpg

http://www.mustangmods.com/data/1619/000_0201.jpg

http://www.mustangmods.com/data/1619/000_0283.jpg

http://www.mustangmods.com/data/1619/000_0285.jpg

Dale McPeters
09-27-2005, 07:19 AM
Very very nice..... :yup:

93Cobra#2771
09-27-2005, 08:54 AM
Pretty! I likee!

coupe
09-27-2005, 09:11 AM
:yup:
mind giving an approximate amount to go from stock to that ??
(not including the spool).

96GTS
09-27-2005, 10:34 AM
:yup:
mind giving an approximate amount to go from stock to that ??
(not including the spool).
I bought the sppol w/ the axles,so...here is a list from another board that asked me...

Moser 33 spline spool and axles $580
FRPP 4.56s $200
TA Performance girdle $160
TA main studs $25
Moser 9” housing ends $80
Moser 9” big bearings $65
Currie labor $200
Gear setup labor $150
3" ARP studs $25
RTV, paint, etc... $20
$1505

Of cousre, you might pay more to set up the R&P, I had a buddy do it??

I also machined the brake plates myself at the machine shop I used to work at...free