Dyno results - Steig ported blower

[mj_8]

Thanks to Travis (NO2MORO) for installing my blower and Blake for the dyno time. If anyone needs good work done by a super nice guy Travis is your answer.

Not bad for only 13.5 PSI

http://www.deepstageperformance.com/images/dynorun2.jpg


http://webpages.charter.net/cmaple/dynorun2.bmp

[Italian LX]

Wow, very impressive. :nice:

[Italian LX]

Btw, I moved this to the Dyno Room and replaced your bmp with a jpg... that 5.8MB pic was taking forever to download. Also, in the future, you may want to consider sizing down the Run Viewer image down to somewhere around 900 x 675 for those of us that don't have 32" monitors. :D

I tried to resize it as an image, but it turned out tooo blurry. You pretty much have to make it smaller using the RunViewer window.

[93Cobra#2771]

What's an "onitor"? :confused: :D

Nice numbers!

[TheJeanyus]

:metal: That's kick ass power from an Eaton at 13.5 psi. :nice:

EDIT: Did you get any pictures of the port work on the blower?

[Skillet]

That torque curve is nice! :drool:

[mj_8]

I only took a few pics of blower but here they are...

He opened up the Plenum side quite a bit.
http://webpages.charter.net/mdj8/Photo_101205_011.jpg

I only snapped one pic of the bottom.
http://webpages.charter.net/mdj8/Photo_101205_007.jpg

The finsihed product.
http://webpages.charter.net/mdj8/Photo_101605_004.jpg

[TheJeanyus]

Man I really like the black finish. Is it powder coated? Your JLT air intake looks a lot better than my Densecharger (meter forward only w/ stock meter to tb tube), too.

[coupe]

:eek: nice setup.

[mj_8]

Thanks fellas.

I spray painted it with high heat engine enamel.

[QWKSNKE]

niiiiiiice :nice:

[99LS1]

damn.

[EZ SPEED]

:nice: