Inserting Probe

[CrazyInBlack]

Now that everyone is looking

I bought a controller for my fan and it has a probe that goes though the radiator. do I need to avoid the water passages in the radiator or put it in a particular area?

also do I need anything else to install this? I seem to remember reading about installing one and they installed a relay or something else

thanks guys

* I thought I would go ahead and post here so no one had to move the thread :jester:

[Italian LX]

What brand controller is it?

[CrazyInBlack]

http://www.oreillyauto.com/EW3/ProductDetail.do?id=12688955&line=HDN&itemNumber=3647&exactItemNumberIndex=0&didSearchFor=3647&bid=1183935931869&cycleCount=1833

[QWKSNKE]

the controller that Brian, I, and a few others on here use or have used (I went back to a manual fan) mounts near the lower radiator hose

[ujslost]

I used one just like it and I had no problems. Put it near the lower hose like Lee stated.

[ujslost]

well i had an infrared temp gun that i used once the motor was up to operating temp, then I set the control.

[CrazyInBlack]

I thought it was supposed to go through the actual radiator not a hose