MLS fitment???
 

Just got these in but not sure if they are right. They are felpro 1133 says4.100 bore 351,svo, will not fit stock head. Well mine are not stock but are stock type (holley) what Ya'll think

http://store.summitracing.com/partde...w=32&N=700+115

It doesn't look like they will work, I think the SVO blocks are siamese bore so they don't have water jackets between the cylinder bores. Is your engine apart where you could compare it to the gasket?

I do not think they will work either

That would be correct!

EDIT: Just FYI,the SVO block is a 4 bolt main too.

they won't work. shoulda ordered them from me. :slap:

Its what your book said.:jester:

no sir. you didn't see the book I was looking at.

I don't trust that book for anything more than truck accessories. :no:

Theyll work just fine. That's the gasket I've been using on my 418W for the past year now.

I don't know why they say they won't work with a stock head... although, Summit has been known to have the wrong info on a lot of their items. I've run across that quite a few times.

I use silicone instead of head gaskets.