New Starter Prob..
 

Ight i put the new flywheel in and it started up perfectly but now when i try to start the car now it still grinds but its not as bad as used to and when i left off of the key it act like the starter kinda keeps going or just stays enganged when i let off the key its acting like it going backwards or somthing like that any ideas this time around?

Bendix is not disengaging. Need to check the wiring at the starter

I did what you said b4 do i need to change it back to the way it was?

http://img35.imageshack.us/img35/3296/selonoid.png

Thats the correct wiring for a mini starter.

Check your ignition switch next to see if it is hanging.Ignition switches were common issues in fox body cars so I'd just replace it if I were you

if thats it then that sucks cuz i dont have all that much more money to put into this car i already put like 2500 in it(thats alot for me) to get it like it is but ill try soon

I even put shim on it and it still does it

after it is cranked and running, check to see if the starter side of the solenoid still has fire. if it does it could be a bad solenoid. also check if it still has fire to see if the the start wire( the one on the little stud) still has fire. if so, then this would indicate a bad ignition switch, which is about a 15 dollar part. these things are notorious for going bad. hope this helps.

just noticed that you put on a mini starter. does it have the solenoid build into the starter? if so i would wire it a little differently. this could be your problem.

yeah its got selonoid on the starter the pic in top of this page is how i have it wired that a memeber on the forums said to wire it

and are u talking about to the key switch or the mechanical parts? of the switch

the electrical part inside the column. i would wire the factory solenoid just as it was from the factory and i would put a jumper wire across the two terminals at the starter. hope this helps.