2003 Silver Cobra
 

This the way the car started after it was fixed. I had to replace the k member, right side arm, right fender, front bumper and do some pulling on the frame. It was completely stock when it was finished
http://i62.photobucket.com/albums/h8...ookatme085.jpg

I done most of the motor mods all at the same time. The blower is a stage 3 port with ported plenum and tb. Upper and lower pullies with reichard idlers. The intake is JLT rai. Fuel system is stock other than a bap.

Exhaust wise I went with bbk longtubes, bbk o/r h pipe and flowmasters welded into the stock exhaust.

Suspension is eibach sport springs with an billetflow irs brace in the rear. Weld prostars are for the track and extra bling
http://i62.photobucket.com/albums/h8...P1010040-1.jpg

Here is a pic of the front spacer to clear the skinnies.
http://i62.photobucket.com/albums/h8...e/P1130025.jpg

Decided to take some more pics of the parts while I was installing them as well. Clutch is a spec stage 3+. Matt hooked me up with a good deal on it. Flywheel is a fidanza aluminum
http://i62.photobucket.com/albums/h8...e/P1130021.jpg

26 spline input shaft with lethal upgraded tob retainer
http://i62.photobucket.com/albums/h8...e/P1130022.jpg

Last pic I could take before the camera ran out. Hard to see but its the slp line lock kit. I'm also doing a driveshaft safey loop and fiore adjuster and quadrant.
http://i62.photobucket.com/albums/h8...e/P1130023.jpg

Looks very much like what I wanted! 03 cobra is my most wanted Mustang.
Whoa!

Lookin' good man!! :metal:

:nice:

How do you like the 3+? I still haven't decided what clutch I'm going to use when the time comes (though it will be a SPEC).