Need help fast please
 

Ok i need help with this all anwsers and pics would help. I need tires and was wondering is 275x50x15 is to big for my car. I have a 15x8 wheel with 5.5" backspacing. And also i have eibach drag launch springs on the car which makes it sit lower in the rear. Please i need help quick with this as i've already ordered the tire and if they dont fit i need to send them back thank you.

Robert

Those should fit fine, its around a 26" tires. If it was a 60 tire I would be worried

ok... all the cars i'm seeing pics of doesnt sit as low as my car does do u think it being lowered in rear will cause fit problems?

It will be fine. Just go ahead and roll your fenders and they will fit just fine without scrubbing

here is a pic of my car with mt 26x10.5 on it
http://i244.photobucket.com/albums/g...peral003-2.jpg
http://i244.photobucket.com/albums/g...peral001-2.jpg
http://i244.photobucket.com/albums/g...ustangs005.jpg

You should be fine. I have the same size tires (ET Street drag radials) on a set of 8" Welds for my coupe. I have Racecraft springs and I think it sits as low (if not lower) than your car. I never had a scrubbing problem.


I can't find any pics of those tires on my car, but here are the same wheeels with some 26x11.50 tires (ET Street slicks).



http://streetstangs.com/images/welds-01.jpg

my car is lowered in the rear and i have 28/11.50 et streets that fit fine and the fenders dont have to be rolled for them but i have a set of bfg 275/50s that rubbed on inside and outter fenders so i had to get the sledge hammer out plus run 1/4 wheel spacers (which i would not recomend if racing) and i had weld rodlites 8in with 5.5 bs hope this helps

Bfg is just a big tire all around isnt it? The tires i have are nitto 555 drag radials 275x50's. Do u think there is a difference between these and bfg?

What i mean is even though they are the same size "275x50" the nitto isnt as wide as the bfg. Seems like i had a friend that had a set of bfg's and never ran them, but he ran a set of mickey thompson drag radials that was 275x50 and all he had to do was roll his lip a little and his backspacing was like 4.5 or 5 i think. I'm going to mount them i guess if i have the same problem u did i'll make them work like u did. thats all i can do i guess. lol

i had a buddy who had m/t drag radial 275/50s and they were half an inch wider than mine