picked up some go parts...
 

Well i ran up on some vic jr heads, carb intake, e cam and polished tall ford valve covers...so i had to get it lol...since i already have a 10sec 331 sitting in the garage floor i figured i would go with a big windsor stroker...just dont know which one..Any suggestions???

393 unless you want to buy a block :)

i was leaning towards the 393..i know im not gonna go with the e cam too small for what i want...probably the anderson n91 or a comp custom grind..

393 with vics and custom grind would be lots of fun!

i hope so...lol i have nitrous kits if its not "fun enough"...D.S.S has their 393 pro bullet short blocks for 2999.00 so might just go that route i had great service and still do out of my 331 i got from them.

393 and vics would work great on a little spray.
My ported hi ports are a little much for my 3.85 stroked windsor so I guess it will always be a titty :baby:
Custom grind cams seem to work wonders when done correctly.

I guess you never really know what a motor will do until you actually get it together lol