StreetStangs.net  

Go Back   StreetStangs.net > Search Forums

Showing results 1 to 6 of 6
Search took 0.00 seconds.
Search: Posts Made By: exgmguy
Forum: Tweecer 09-18-2005, 09:06 AM
Replies: 25
Views: 2,681
Posted By exgmguy
Re: Accel pump multiplier-Global

I kept increasing the accel global multiplier until my wideband showed no lean spike on tip in. I think it is set around 1.6 right now.
Forum: Tweecer 09-14-2005, 06:30 PM
Replies: 12
Views: 6,049
Posted By exgmguy
Re: How to hook up my LM-1 wideband to my Tweecer?

Yup, I had the wrong wire hooked up. The white wire needs to go to pin#27. It is dead nuts now.

Thanks!
Rob
Forum: Tweecer 09-14-2005, 01:16 PM
Replies: 12
Views: 6,049
Posted By exgmguy
Re: How to hook up my LM-1 wideband to my Tweecer?

I did disable the EGR, as well as the payload and wideband selections. I am wondering if I have to have the red AND the white wire from the analog out on my LM-1 hooked up. I have only the red wire...
Forum: Tweecer 09-13-2005, 09:07 PM
Replies: 12
Views: 6,049
Posted By exgmguy
How to hook up my LM-1 wideband to my Tweecer?

I posted this on the EECtuning board as well.

I do have the EGR sensor unplugged. There are 3 analog out wires from my LM-1. A red, white, and a ground. I have the white wire not connected to...
Forum: Tweecer 09-10-2005, 06:51 PM
Replies: 62
Views: 6,442
Posted By exgmguy
Re: Lets start a load value thread

My car was idling at 35%, and would hit 100% with a very small amount of throttle. I think this was causing a part throttle rich condition. I added to the sea level function, and changed my cubic...
Forum: Tweecer 09-10-2005, 06:37 PM
Replies: 5
Views: 1,313
Posted By exgmguy
Re: Lean on Tip in

I had the same problem, and fattening up the MAF curve down low did the trick.
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -6. The time now is 01:26 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.