Forum: Tweecer
06-26-2006, 03:57 PM
|
Replies: 12
Views: 5,029
Re: Round one of newb questions
Alright, I plan on doing all of my tuning with the tweecer. I wanted to shut off adaptive and force open loop, because I am absolutly terified of running lean when I'm in boost. It may never...
|
Forum: Tweecer
06-25-2006, 04:33 PM
|
Replies: 12
Views: 5,029
Re: Round one of newb questions
Jason,
I will be running an A9* computer. Form what I have gathered, if I shut down the adaptive learning, then the motor will shoot for an A/F ratio that I dictate, not what has been learned.
...
|
Forum: Ford Pushrod Tech (5.0 & 5.8)
06-24-2006, 07:20 PM
|
Replies: 3
Views: 505
Re: Valve Spring Q's
Thanks ya'll. Think I am going to have him cart them off to a good shop to give them a look. I can honeslty say that what they are are anybodies guess!
thanks again!
|
Forum: Ford Pushrod Tech (5.0 & 5.8)
06-20-2006, 04:36 PM
|
Replies: 3
Views: 505
Valve Spring Q's
A friend of mine had a set of 351W heads built while he was in California. the problem is, he lost the info on the springs.
They are double springs, with the inner spring having a blue stripe, and...
|
Forum: Tweecer
06-17-2006, 06:46 PM
|
Replies: 3
Views: 2,623
|
Forum: Tweecer
06-17-2006, 04:47 PM
|
Replies: 3
Views: 2,623
2000 GT MAF on an EEC-IV computer
Will the above mentioned meter run on an EEC-IV? I'm asking because I can get one way cheap, and would like to use it for a mass air conversion on my speed density car.
Even if it won't run...
|
Forum: Tweecer
06-07-2006, 01:09 PM
|
Replies: 12
Views: 5,029
Re: Round one of newb questions
Thanks for the replies everyone. At least I seem to have somwhat of a clue.
I asked about he MAF, because I plan on running a 90mm MAF cal's for 42's on a set of 19's. I am going to try an...
|
Forum: Ford Pushrod Tech (5.0 & 5.8)
06-06-2006, 07:22 PM
|
Replies: 12
Views: 1,878
Re: Supercharger
If the tune is right, you should make more power with a good set of heads, at the cost of some boost. You will actually lose boost with free flowing heads, but overall power will be up.
As for...
|
Forum: Tweecer
06-06-2006, 05:19 PM
|
Replies: 12
Views: 5,029
Round one of newb questions
Let me start by saying that I have absorbed as much information on the EEC as I could, and have a couple of questions for ya'll just to see if my brain is tracking the right way.
1. If I tell the...
|