[exgmguy]

I posted this on the EECtuning board as well.

I do have the EGR sensor unplugged. There are 3 analog out wires from my LM-1. A red, white, and a ground. I have the white wire not connected to anything, the red to pin 27 on the EEC harness, and the ground to the body right behind the ECM kick panel.
The display is reading richer than my LM-1 is showing and I don't know why.
Anyone have any ideas?? When I select "innovative" from the dropdown menu in Calcon it reads WAY rich, about 4/1 at idle. If I select "PLX" from the menu It reads closer, but still shows around 12/1 when the handheld LM-1 display is in the 14's.

Thanks,
Rob