Quote:
Originally Posted by Italian LX
I believe that was the biggest reason Lee was wanting to do this. The PMS also has some WOT nitrous features too, but beyond those, I personally don't know what the PMS has to offer.
|
Ok I can answer most of this as I got to go to school on Sunday....
The PMS Series IV benefits in stand-a-lone mode >
Nitrous Control
Boost reference (map sensor). Can control timing better under boost.
Engine can be turned to a higher rpm than 7000-7500 without changing the crystals in the EEC-IV. As some EEC-IV's are limited in this regard.
Plus other stuff that Lee listed above.
Quote:
Originally Posted by Italian LX
Wow, that a very good question that I didn't even think about.
What about it, Dale? Do you think this is possible?
|
No datalogging with the TwEECer when the PMS takes control in stand-a-lone mode as the TwEECer is taken out of the picture just like the EEC-IV. It will still be working but I would use the PMS/Interact software to datalog when the PMS goes onto stand-a-lone mode.
Clear as mud yet?