[EHardy1971]

From the thread on the Corral...

The other new product we brought is actually for a small Chevy, it is a dual plane intake...made of PLASTIC. Yes it works, has been on the dyno, and is quite amazing all around.
The reason I mention this, is we are of course planning on a couple Ford manifolds; a dual plane, and a single plane. We are also not forgetting about our injected guys, our goal is to have a Long runner, short runner, and box available with either a 5.0 or 5.8 stock deck height lowers.

The Chevy dual plane was 10hp and 10 ftlbs better then our competitor. We tested our prototype single plane (Aluminum of course) against the competitor, we picked up over 20 on both ends, we will see more in plastic due to temperature differences.

On a 14 second dyno pull, the surface temp of the aluminum manifold was 118 degrees, our plastic was a whopping 30 degrees cooler at 88....not too mention the weight went down from 16 to 9lbs. The weight savings will be huge on a bulky 5.0 style manifold.

We expect our full line to be out with-in a year, but are aiming for much less.
***********************************

I will be at the SEMA show all day tomorrow, so please keep it as civilized as possible

Have a great day guys,
Jason
__________________
AFR Tech/Sales (661) 257-8124 Ext. 124
Direct line (661) 705-8520

http://forums.corral.net/forums/show...=1#post8227149