[slvrbullit]

Do you have this problem? I did until I was sitting there about ready to pull out the 9 and put the EEC out of my misery. Had been talking to Lee and Brian about this and they both suggested a bad/corrupt file. Well I said ok and re read the stock eec and saved it to desktop, then I wrote that file to the tweecer and fired it up and started a log file, bam 35k volts at idle on the MAF voltage. SO I go thru and look at everything, turns out that the utilities for the items to log are unchecked even though some of the positions I have on the tweecer have them as checked when I wrote the files.

I then procede to re write the tweecer but with the appropriate boxes checked, this takes care of the super high MAF voltages.

Is it normal for you to have to go to utilities and select a payload everytime when writing a new file? Just curious.

Thanks, hope this helps others that have this problem.
Tommy