StreetStangs.net  

Go Back   StreetStangs.net > Technical > Dyno Room

Reply
 
Thread Tools Display Modes
Old 04-08-2007, 05:40 PM   #21
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
how does the car run?does it feel strong?

still waiting to hear if it has stud mount or pedestal mount rockers
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 05:40 PM   #22
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
stud mount
QWKSNKE is offline   Reply With Quote
Old 04-08-2007, 05:41 PM   #23
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
wonder if the valves are adjusted too loose??
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 05:42 PM   #24
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
Quote:
Originally Posted by qkjuicedpony View Post
wonder if the valves are adjusted too loose??

They were not noisy when I drove it after installing 3.73's a few months ago.
__________________
2009 Porsche Carrera S
2008 ///AMG C63.. Eurocharge Tune. RIP
2019 AMG GLC43..wife's
03 F250 SD.. Edge Evo, AFE Stage 1 CAI
08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's
01 Cobra vert... wife's

I need a new toy
QWKSNKE is offline   Reply With Quote
Old 04-08-2007, 05:45 PM   #25
Crzypny
Senior Member
 
Crzypny's Avatar
 
Join Date: Aug 2005
Location: Hoover, Al
Posts: 576
Quote:
Originally Posted by QWKSNKE
They were not noisy when I drove it after installing 3.73's a few months ago.
And a fine job I might add!


I can definitely tell a difference in the way it feels.

Clutch is original, never been replaced, and Lee you know the vibration in the drive shaft I have .... just wondering how much of an issue these could be to loosing power to the wheels.
Crzypny is offline   Reply With Quote
Old 04-08-2007, 05:46 PM   #26
qkjuicedpony
Dayuuuuuuum!!!!!
 
qkjuicedpony's Avatar
 
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
if the clutch is old and is slipping then it will show a power loss.
__________________
86 Mustang Gt......Mods piling up in my garage.

07 F350 dooly.....Tows my fifth wheel
qkjuicedpony is offline   Reply With Quote
Old 04-08-2007, 05:53 PM   #27
QWKSNKE
3v's are slow
 
QWKSNKE's Avatar
 
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
driveshaft won't cause a power loss it will just suck when you carry it up in the rpms.

I agree with qkjuiced. The clutch could be causing a problem since it is the OEM one. It may be slipping just enough to cause a power loss without noticing it.
QWKSNKE is offline   Reply With Quote
Old 04-08-2007, 06:36 PM   #28
Crzypny
Senior Member
 
Crzypny's Avatar
 
Join Date: Aug 2005
Location: Hoover, Al
Posts: 576
Quote:
Originally Posted by QWKSNKE View Post
driveshaft won't cause a power loss it will just suck when you carry it up in the rpms.
Ok, I was curious about that since it's not a smooth transfer of power from the tranny to the rear end.
Crzypny is offline   Reply With Quote
Old 04-09-2007, 06:49 AM   #29
1sicklx
BamaMafia 4 Life
 
1sicklx's Avatar
 
Join Date: Feb 2005
Location: Lake View, AL
Posts: 2,577
Quote:
Originally Posted by qkjuicedpony View Post
wonder if the valves are adjusted too loose??
3/4 of a turn past 0 lash.

Quote:
Originally Posted by qkjuicedpony View Post
how does the car run?does it feel strong?
After Doug added the chip the car runs great, good throttle response, good idle ... feels strong compared to before it was tuned :P
__________________
1999 Ford F-150 Lariat

Last edited by 1sicklx; 04-09-2007 at 06:53 AM.
1sicklx is offline   Reply With Quote
Old 04-09-2007, 07:51 AM   #30
coupe
Super Moderator
 
coupe's Avatar
 
Join Date: Dec 2004
Posts: 6,313
1.7's would be the easiest. But the TFS cam will run circles around the B303.

The car went 103mph in the 1/4. It has to have more in it than 260.
__________________
" If you can't explain it simply, you don't understand it well enough. " - Albert Einstein
coupe is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 07:32 AM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.