trans to bellhousing bolt - Page 3

Shorty · 07-13-2010, 02:11 PM

Quote:

Originally Posted by coupe

put driveshaft on and if it vibrates, re-install 90º rotated... do this until it is back smooth again. Not a difficult task. Loc-tite on final one.

i was afraid that was gonna be the answer. lol

Shorty · 07-13-2010, 02:23 PM

Quote:

Originally Posted by QWKSNKE

there is a yellow paint mark on the driveshaft. Align that with the with the factory yellow paint mark on the pinion flange and you will be good to go

Sometimes tranny's will be a pain in the ass to push all the way up. The t-5 in my old cobra used to give me and Brian hell anytime we were reinstalling it. Most other cars we never had a majo problem with. Did you grease up your bearing retainer?

i greased it but very very little due to it being so close to friction surfaces. some sources i read said to grease, others not to. a little more may not hurt along with the fact i am doing this 100% alone so aligning and muscling at the same time is difficult. it seems to be stopping movement when it gets to where the throwout bearing collar meets the trany which i was contributing to it being new and possibly not quite just the same as the original. guess i will back it off, try a little more grease and go from there.

thanks all

QWKSNKE · 07-13-2010, 05:44 PM

Grab it by the tail shaft and wiggle/push the sh** out of it

TheJeanyus · 07-13-2010, 06:17 PM

Quote:

Originally Posted by QWKSNKE

Grab it by the shaft and wiggle/push the sh** out of it

EHardy1971 · 07-14-2010, 02:03 AM

Quote:

Originally Posted by TheJeanyus

QWKSNKE · 07-14-2010, 07:51 AM

Quote:

Originally Posted by TheJeanyus

Sometimes you have to do that with a big shaft

86GTPONY · 07-14-2010, 08:00 AM

Quote:

Originally Posted by QWKSNKE

Sometimes you have to do that with a big shaft

I have to agree!

TheJeanyus · 07-14-2010, 08:19 AM

Quote:

Originally Posted by QWKSNKE

Sometimes you have to do that with a big shaft

Who have you been helping with their shaft then?

93cobra1928 · 07-14-2010, 06:12 PM

Quote:

Originally Posted by TheJeanyus

Who have you been helping with their shaft then?

Why do you know it's not his?

QWKSNKE · 07-14-2010, 07:45 PM

Quote:

Originally Posted by 93cobra1928

Why do you know it's not his?

EXACTLY

07-13-2010, 05:44 PM	#23
QWKSNKE 3v's are slow Join Date: Dec 2004 Location: Here and There Posts: 17,152	Grab it by the tail shaft and wiggle/push the sh** out of it __________________ 2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy