|
11-15-2010, 11:11 AM | #1 |
Senior Member
|
Stall issue with 03 Mach 1
I can't make this happen and it only happens occasionally.
Most of the time when turning left from a stop. Ease out of the clutch into the throttle. The car starts to roll and then stalls, with dashes appearing on the odometer. Coast to a complete stop, turn the switch completely off and start the engine. Engine starts with no problem at all and the car runs fine. Like I said at first, it mainly happens when starting and making a left turn. It has happened twice when starting in loose gravel in a straight line. Tac Bear put his Diablo Programmer on it and it showed no codes, any ideas. When making a U-turn or a hard left turn at times the car wants to stumble under acceleration. I have been told that it is possibly a wheel sensor that is going bad.
__________________
Mean Little Man Last edited by redhorse; 11-15-2010 at 11:15 AM. |
11-15-2010, 12:19 PM | #2 |
Dayuuuuuuum!!!!!
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
|
I had this issue on my wifes convertible last year and it turned out to be a short in the crank sensor wires.
__________________
86 Mustang Gt......Mods piling up in my garage.
07 F350 dooly.....Tows my fifth wheel |
11-15-2010, 07:36 PM | #3 |
Senior Member
Join Date: Aug 2010
Posts: 221
|
It definatly sounds to be a wiring issue. possibly in the steering column
|
04-04-2011, 01:51 PM | #4 |
Friends
|
Found the problem yesterday. It has a diablo switch chip in the ecu. When I removed the ecu the chip fell out. The chip was not fully seated on the board, suprised it did not fry the ecu. I removed the chip and will program it with a hand held.
|
|
|