03-24-2008, 06:16 PM | #1 |
Trunk Monkey
Join Date: Jun 2007
Location: Home
Posts: 5,708
|
Need some valve spring input here!
Ok,I've been reading up on Crane's website,and found some single springs (with dampers),that work on factory heads with no machine work.My first question is,does anybody know if they work with the factory retainers? Next question,does anybody know the installed height of AFR 165 springs?,I have a complete like new set,that are rated for .550 lift,but would require new retainers.I'm going to do this right,but at the cheapest option.I'm really leaning towards just getting a matched set of Crane springs/retainers(which I know will be the BEST way to go),that are good for .550 minimum,because I'm going to put my 1.7's on the GT-40's,which with the E cam,will bump my lift from .498 up to .528. It's been a long time since I built up some high performance heads,so I'm a bit rusty! Just need some suggestions guys,thanks!
__________________
Eric 89 LX Coupe-Juiced 01 Lightning-Boost 06 TBSS |
03-24-2008, 06:41 PM | #2 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
I ran trickflow's OEM spring replacement kit on my OEM GT-40's when they were on the cobra. Pretty sure they came with locks and retainers. Look them up on Summit's web catalog. Its been a few years but the kit was only around $120 at the time
__________________
2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy |
03-24-2008, 08:48 PM | #3 |
Dayuuuuuuum!!!!!
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
|
Crane has a full set with locks and retainers....use them and you will be fine.I have used them several times
__________________
86 Mustang Gt......Mods piling up in my garage.
07 F350 dooly.....Tows my fifth wheel |
03-24-2008, 08:53 PM | #4 |
Trunk Monkey
Join Date: Jun 2007
Location: Home
Posts: 5,708
|
Do you remember the number of the kit?
__________________
Eric 89 LX Coupe-Juiced 01 Lightning-Boost 06 TBSS |
03-24-2008, 09:21 PM | #5 |
Dayuuuuuuum!!!!!
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
|
i will look for the number.i think i have one of the kits laying in the shop
__________________
86 Mustang Gt......Mods piling up in my garage.
07 F350 dooly.....Tows my fifth wheel |
03-24-2008, 10:08 PM | #6 |
Trunk Monkey
Join Date: Jun 2007
Location: Home
Posts: 5,708
|
Cool,thanks man!
__________________
Eric 89 LX Coupe-Juiced 01 Lightning-Boost 06 TBSS |
|
|