04-01-2006, 05:15 AM | #1 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
FYI. Datalogging with LM-1 in Calcon (Tweecer)
After playing with this for a week, finally got it hooked up and working. Since the 'other' site yielded no results in search on how to hook up, here is a detailed explanation.
1) Before installing w/b sensor into exhaust, hook cables and sensor up to control box and calibrate per instructions. 2) Install Data Q software 3) With wideband disconnected from data Q, calibrate data Q per instructions. To find which com port you are using go to control panel>system>device manager. Mine was setup as COM port 4 4) Plug in analog out cable, hook up WHITE wire to Ch. 1, black wire to GND, and run another wire from GND to a chassis ground (preferably to the EEC chassis ground) 5) Open Calcon and select the setup tab. Under DataQ 4 channel logger, select the check box for ch 1. Then select “Innovate†in the first pull down box and A/F in the 2nd. On the right hand side of the screen change sample rate to 10000. 6) Apply changes |
04-03-2006, 04:51 PM | #2 |
5.0 Block/Walnut Cracker
Join Date: May 2005
Location: Working....
Posts: 2,409
|
Re: FYI. Datalogging with LM-1 in Calcon (Tweecer)
__________________
'14 Dodge Challenger SRT8 392 6-speed |
10-04-2006, 05:14 PM | #3 |
Super Moderator
Join Date: Dec 2004
Location: on the water
Posts: 1,280
|
Is this using the cable that came with the LM-1 or you have it wired into an unused EGR harness? Also will it be that same for the LC-1?
__________________
2012 Jeep Wrangler Unlimited--- too many mods to list, about to be sitting on 1 ton axles. 2000 Ford F-350 Dually Lariat LE Crew Cab Short Box 7.3 auto 168,000 miles |
10-04-2006, 05:53 PM | #4 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
Came with the LM-1
|
10-04-2006, 06:20 PM | #5 |
Super Moderator
Join Date: Dec 2004
Location: on the water
Posts: 1,280
|
Cool, so you have the LM1 and tweecer hooked into your laptop at the same time?
__________________
2012 Jeep Wrangler Unlimited--- too many mods to list, about to be sitting on 1 ton axles. 2000 Ford F-350 Dually Lariat LE Crew Cab Short Box 7.3 auto 168,000 miles |
10-04-2006, 07:14 PM | #6 |
Senior Member
Join Date: Nov 2005
Location: Graham AL
Posts: 1,461
|
What mustang is this in?
__________________
''Life's tough... it's even tougher if you're stupid.'' - - John Wayne |
10-04-2006, 08:18 PM | #7 |
Super Moderator
Join Date: Dec 2004
Location: on the water
Posts: 1,280
|
Me or Lee.
If me then it is going into my 95 GT.
__________________
2012 Jeep Wrangler Unlimited--- too many mods to list, about to be sitting on 1 ton axles. 2000 Ford F-350 Dually Lariat LE Crew Cab Short Box 7.3 auto 168,000 miles |
10-05-2006, 05:29 AM | #8 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
|
10-10-2006, 09:37 AM | #9 |
Member
Join Date: Aug 2005
Location: Georgetown Ky
Posts: 48
|
I assume your using one of the 4 channel data acquisition units with USB. this device works very well. We are actually planning on purchasing several of these units for my work to monitor some tests that we perform.
In regards to the EGR wiring... I don't see why the LM-1 would not work wiring it up using that circuit... but some require the EGR for E-testing.
__________________
306 (stock block),TFS Track Heat Heads, E303 Cam, TFS track heat intake, 70 mm TB, 75mm Pro-M,42 lb injectors,Aeromotive AFPR, 255 lph intank, Crane Hi-6/LX-92. Turbonetics 60-1 hi-fi Best ET: 11.88 @ 117mph 427 HP/ 480 ftlb TQ |
|
|