05-12-2008, 11:41 PM | #1 |
marlboro man
Join Date: Apr 2008
Posts: 373
|
Question about stock 5.0 Harmonic balancer
okay, looking at my balancer, its thin, then it gets wide. my question is, are the timing marks only on the wide part? i cleaned it off with PB rust eater and wiped it real good with a Scotch bright pad. and looked it over really good with a BRIGHT LED light, i see no numbers. just notches.so is the notch on the very middle of the wide part 0? or what? this is beginning to be a Mother****. I'll try to take pic's of it if anyone needs to see exactly what i am talking about
__________________
|
05-12-2008, 11:54 PM | #2 |
Senior Member
Join Date: Jun 2007
Location: bham and auburn
Posts: 337
|
brillo pad it get some white out and mark the ten degree before tdc and give it a little more away from zero from that mark.
__________________
finally got my avatar. it is the white one. |
05-13-2008, 02:10 AM | #3 |
marlboro man
Join Date: Apr 2008
Posts: 373
|
any of them could be that mark, i have no idea what those holes or anything mean LOL that is what i am trying to figure out
__________________
|
05-13-2008, 06:47 AM | #4 |
Senior Member
Join Date: Jun 2007
Location: bham and auburn
Posts: 337
|
there should be one big line. that is zero. look to the left and you will see other marks. there should be some somewhat short ones than one inbetween the big long one and the somewhat short ones in lenth and the first one is 10*.
__________________
finally got my avatar. it is the white one. |
05-13-2008, 05:05 PM | #5 |
marlboro man
Join Date: Apr 2008
Posts: 373
|
ok, the big line is 0. to the left of that is retard to the right is advance, according to the Haynes manual. i should have it from here then. unless the dist is a tooth off or something.
__________________
|
|
|