just started tweecing, need a couple of things

MikeyStang · 10-20-2006, 12:03 AM

i have a 95 mustang with a 91 5.0/aod/A9P and need a couple of things
heres a list of my mods
GT40x Heads
E303 Cam
Cobra manifold
73mm C&L MAF (19lb)
bbk 65mm tb
mac full length headers
mac offroad h pipe
mac pro dumps

i really need to get my hands on a MAF transfer function for a 73mm C&L (19) i have one now, but everytime i punch it into the tweecer and go to save it, for some goddam reason, the tweecer resets the entire transfer function back to the way it was

also, injector timing would be awesome!

heres a list of the things ive entered into my tune so far
checksum base address - 0
nuetral idle - 850
gear idle - 950
fuel shutoff decel min ect - 254
fuel shut off shifting min rpm - 2000
max maf voltage - 5
min maf voltage - 0
ISC max closed throttle idle - 948

with this stuff punched in, i have a surging idle, could it be because i dont have the throttle screw 1 full turn in.. the initial timing is set to 10*

got any other suggestion/tips for me
thanx

10-20-2006, 12:03 AM	#1
MikeyStang Junior Member Join Date: Oct 2006 Posts: 3	just started tweecing, need a couple of things i have a 95 mustang with a 91 5.0/aod/A9P and need a couple of things heres a list of my mods GT40x Heads E303 Cam Cobra manifold 73mm C&L MAF (19lb) bbk 65mm tb mac full length headers mac offroad h pipe mac pro dumps i really need to get my hands on a MAF transfer function for a 73mm C&L (19) i have one now, but everytime i punch it into the tweecer and go to save it, for some goddam reason, the tweecer resets the entire transfer function back to the way it was also, injector timing would be awesome! heres a list of the things ive entered into my tune so far checksum base address - 0 nuetral idle - 850 gear idle - 950 fuel shutoff decel min ect - 254 fuel shut off shifting min rpm - 2000 max maf voltage - 5 min maf voltage - 0 ISC max closed throttle idle - 948 with this stuff punched in, i have a surging idle, could it be because i dont have the throttle screw 1 full turn in.. the initial timing is set to 10* got any other suggestion/tips for me thanx