03-19-2005, 06:56 PM | #1 |
Friends
Join Date: Dec 2004
Posts: 1,645
|
Need a Drive shaft
Damn it, I put everything together today, went to put my grive shaft in, and would not go in at the pinion. So I pull it and looked inside of the yoke, damn it! the splines look like a bunch of SSSSSSS. So I put a stock one that I have in it and went in with a 1" of traveling up and down. Question, can I put the yoke of the stock drive shaft and put it on the aluminum one? The one from the aluminum is long, the stock one is a bit shorter, will the u joins be the same diameter like the ones in the FMS drive shaft? Damn I thought I was done.
Edgar |
03-19-2005, 09:15 PM | #2 |
Nothing new here
Join Date: Dec 2004
Location: Senoia, GA
Posts: 2,990
|
Re: Need a Drive shaft
Measure the diamtere of the bearing cups, and the length's to see if they are about the same size.
Doesn't Steeda sell a drive shaft spacer, could this help you at all?
__________________
1974 Triumph TR6 1985 Monte Carlo SS 1986 Mustang GT 2011 KIA Optima GTS |
03-20-2005, 12:44 PM | #3 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
Re: Need a Drive shaft
I think the u-joints are bigger in the FMS driveshafts but I am not sure.
__________________
2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy |
03-20-2005, 04:44 PM | #4 | |
Friends
Join Date: Dec 2004
Posts: 1,645
|
Re: Need a Drive shaft
Quote:
Edgar |
|
|
|