02-03-2011, 03:26 PM | #11 |
Member
Join Date: Jan 2011
Posts: 82
|
I would think it would be good. Whats the power range for that cam? 545/565 should be pretty good.
__________________
Just your average 92 Coupe with a Cam Only 302! Drive it like you stole it because everyone dies but not everyone lives! |
02-03-2011, 07:57 PM | #12 |
ADDICTED TO SMALL BLOCKS
Join Date: Jan 2007
Location: lookout mt
Posts: 1,757
|
I would check the dynamic compression with cam specs and engine specs.Also would figure out the quench pad area to see if its tight enough.
From just looking at the flow numbers on the pc heads the low and mid lift numbers are a little low adding all the lift numbers together those fall shorter than you think compared to some of the supposedly lesser heads.jmho Naturally aspirated I would think for them to work decent you would need to have pretty low gearing and launch it at high rpms there fore requiring a little more carb and cam.The larger cam would need more static compression to keep dcr up either way their will be a compromise somewhere.But if you are going to juice it all the time they should respond good again jmo
__________________
http://alabamaopencarry.com/forum/index.php One of StreetStangs class clowns! Status:slow as hell! NORTH EAST ALABAMA STANGS Last edited by waypastcrazy; 02-03-2011 at 08:09 PM. |
02-03-2011, 08:46 PM | #13 |
5.slo stanger
Join Date: Jan 2007
Location: oxford alabama
Posts: 735
|
hey hey got a built 351 forsale so i would def go with the 351
__________________
no mustangs anymore but i do have a 1jz swapped 83 supra |
02-03-2011, 10:23 PM | #14 |
Trunk Monkey
Join Date: Jun 2007
Location: Home
Posts: 5,708
|
Better yet, find a 351 from a '94 up F/E series (F4TE block), they're roller blocks.
__________________
Eric 89 LX Coupe-Juiced 01 Lightning-Boost 06 TBSS |
02-04-2011, 05:45 PM | #15 |
5.slo stanger
Join Date: Jan 2007
Location: oxford alabama
Posts: 735
|
mine is setup for solid roller ill shutup now
__________________
no mustangs anymore but i do have a 1jz swapped 83 supra |
02-05-2011, 09:11 AM | #16 |
Senior Member
Join Date: Nov 2006
Posts: 488
|
I got a very low mi. Rollor 351 shortblock std. Bore and foxbody oilpan 500.00 bucks
__________________
Preston 1947 mercury 2door coupe 331w/tko 600 project 2003 f350 5in lift 6.0 with upgraded stuff!!! |
02-10-2011, 03:37 AM | #17 |
Junior Member
Join Date: Oct 2009
Location: oxford
Posts: 9
|
still have it? lookin to build a 408 stroker and wouldnt mind a std block to start w...
__________________
306 Street Build ... A little and a little got me a whole lot of ... |
|
|