03-16-2007, 10:18 PM | #1 |
Bet I red light B4U
|
Lower Control Arms
Looking into getting a new set of LCA. What kinda are ya'll running? Are there any bad ones I need to stay away from?? Just trying to get some good opinion before the purchased. Thanks in advance.
|
03-17-2007, 07:24 AM | #2 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
What are you running now? For which car?
__________________
2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy |
03-17-2007, 08:14 AM | #3 |
Bet I red light B4U
|
They'll be for the GT. I fab up a set years ago from some roll bar tubing,but the bushing I used didn't hold up. Thought about getting a set that you can adjust ride height. Any one have any luck with them?
|
03-17-2007, 08:58 AM | #4 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
I think the weight jackers are suppose to be good
__________________
2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy |
03-17-2007, 03:42 PM | #5 |
pro-jackstand racer
|
I ran the "cheapies" from JD's performance. No problems, think they were copies of someone elses design. I got a deal on them b/c the color of the powder coat turned out too "orange"...
__________________
And God created Neil Peart so that lightning would make sense to the world.
~~~~~~~~~~~~~~~~~~~~~~~~~~~ |
03-17-2007, 04:44 PM | #6 |
Dayuuuuuuum!!!!!
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
|
i run the steeda weight jackers with great results
__________________
86 Mustang Gt......Mods piling up in my garage.
07 F350 dooly.....Tows my fifth wheel |
03-17-2007, 04:55 PM | #7 |
Senior Member
Join Date: Nov 2005
Location: Graham AL
Posts: 1,461
|
http://www.evolutionmsport.com/evmCa...roducts_ id=4
I just put mine on. Very strong. 3 – piece urethane bushing on the chassis end and spherical bearing on the axle end. My svo is within a half inch all the way around now. With the stock arms one side was 1.5" lower than the other. I used a set of the cheap arms for a while and the bushings are broken from only 4K miles. Buy the nice ones and never look back. Steeda was my first choice but I got these in a trade.
__________________
''Life's tough... it's even tougher if you're stupid.'' - - John Wayne |
03-18-2007, 09:59 AM | #8 |
Junior Member
Join Date: Feb 2007
Location: Bham, AL
Posts: 19
|
The upr ones are pretty nice and work too.
|
|
|