11-12-2007, 05:25 PM | #1 |
Senior Member
Join Date: Oct 2006
Location: at your moms
Posts: 407
|
wheel stud installation tool
i just need to know if i can barrow one of these handy tools next week, im installing weld racing wheels on my 2000 there fore needing to put longer studs in it. or if some one can send me a link where they sell this tool, i dont know what im looking at when i google this tool.
__________________
13.068 @ 102 with a 1.732 60 ft, 4:30 gears and drag radials, 2.5 inch exaust, x pipe w/ flowmasters, stock motor and trans |
11-12-2007, 05:46 PM | #2 |
3v's are slow
Join Date: Dec 2004
Location: Here and There
Posts: 17,152
|
I have never seen a tool other than a hammer and a socket to fit a lug nut
__________________
2009 Porsche Carrera S 2008 ///AMG C63.. Eurocharge Tune. RIP 2019 AMG GLC43..wife's 03 F250 SD.. Edge Evo, AFE Stage 1 CAI 08 GT. JBA axle back, FRPP springs, FRPP swaybars.. daughter's 01 Cobra vert... wife's I need a new toy |
11-12-2007, 05:55 PM | #3 |
Halfshaft Killer
Join Date: Mar 2005
Location: The Kingdom
Posts: 3,910
|
Werd. A bfh works well to knock them out. An open lugnut and washers works well to pull the new ones in.
__________________
03 Cobra 06 F250 (\__/) (='.'=) (")_(") |
11-12-2007, 06:17 PM | #4 |
Daddy x4 ...we're done
Join Date: Dec 2004
Location: Oxford, AL
Posts: 11,551
|
Yeah, I've never seen a special tool for it. The above recommendations should work fine.
FWIW, I pressed mine in using an A-frame press.
__________________
-Brian '86 Mustang GT Convertible '88 Mustang LX coupe '11 Odyssey TE '21 Insight Touring |
11-12-2007, 06:17 PM | #5 |
Mine's bigger...
|
19/64" drill bit for the front hubs. Knock stock studs out with hammer, drill out the holes and use an old lug nut and washers stacked up to pull the stud through w/ an impact gun or Tbar lug wrench.
Rear axles, dnt need to be drilled out.
__________________
323rwhp | 320rwtq - 4VNA 12.13 @ 113.36 | 1.63 60' |
11-12-2007, 09:59 PM | #6 |
Dayuuuuuuum!!!!!
Join Date: Dec 2004
Location: Dallas GA
Posts: 2,933
|
if you have a friend with a BallJoint press tool.you can use it to install the new studs along with an impact wrench.works perfectly
__________________
86 Mustang Gt......Mods piling up in my garage.
07 F350 dooly.....Tows my fifth wheel |
|
|