02-13-2005, 03:41 PM | #1 |
Friends
|
? on brakes for the 03cobra.
It is time for me to replace my brakes, the tech at Ford said that I will need new rear rotors when I change them out. So I have been looking into the slotted and crossed drilled rotors for my car. Ford racing only makes the front rotors and I was looking at the powerslot for the rear. On my car will the holes and slots help any or should I just go with the factory rotors and save so money?
|
02-13-2005, 04:47 PM | #2 |
Im gonna show her my...
Join Date: Dec 2004
Location: Somewhere providing FREE tech support.
Posts: 4,269
|
Re: ? on brakes for the 03cobra.
NO POWERSLOTS!
Baer Eradispeed rotors for the front with Performance Friction Z-rated (from Auto Zone) Stock Ford for the rear with Hawk HPS for the rear. Ford HP DOT3 Brake Fluid This is the setup on my car, and it stops like I dropped anchor!
__________________
I heard it on the internet, so it must be true. "I believe that a person's moral compass can be determined by how he references free men the right to defend themselves." T. Nugent "An armed society is a polite society. Manners are good when one may have to back up his acts with his life." R. Heinlein "Never argue with an idiot. They drag you down to their level, then beat you with experience." -Unknown |
02-13-2005, 08:56 PM | #3 |
Nothing new here
Join Date: Dec 2004
Location: Senoia, GA
Posts: 2,990
|
Re: ? on brakes for the 03cobra.
Unless your balls out racing on a high turn count short track, then I don't think I would waste the money on upgrading your rear rotors.
Like Nathan said, try out the PF Z-rated front pads, I have several friends that ran these in track touring and they do pretty good, there and on the street. I personnely don't have any preferance on rear pads, I run some cheap ones on my '85, but I also run almost all front brake where I have very good pads. I have seen somewhere that you can buy the same pad as what was on the 2000 R for the rears.
__________________
1974 Triumph TR6 1985 Monte Carlo SS 1986 Mustang GT 2011 KIA Optima GTS |
02-14-2005, 10:10 AM | #4 |
Senior Member
|
Re: ? on brakes for the 03cobra.
I've got good used rear rotors and new cross drilled ones. My preference on pads is no secret....but whatever you choose make sure you get a pad that is not made up of materials harder than the rotor surface.
__________________
Drifting is to road racing as figure skating is to hockey. |
|
|